Temperature Drops after Print Starts - AO-101 & AO-100 - LulzBot

Hey Guys, So I had to put in new thermistor recently, did some other structural changes (60mm height increase) and wired in a fan which isn’t currently connected. Yet now I am getting this issue with my hotend where once the print start the temperature drops even though it looks like the extruder is still rocking it. I ran PID autotune, stored the values, brought the bed and then the hotend up too 230C using Repetier. Then I dropped in the GCODE. You can see down below the temperature curve. T

LulzBot Mini 2 Review

Extruder Struggling - AO-101 & AO-100 - LulzBot

omgthx/factoids.json at master · McBride36/omgthx · GitHub

Mosaic Palette Users Pikachu printed on a Makergear M2 and Palette 2 pro.

TweakTown's Guide to 3D Printing: Part 1 - What makes up a 3D Printer?

Introduction to Low-Cost 3D Printing

High-performance polymer 3D printing – Open-source liquid cooled scalable printer design - ScienceDirect

High-performance polymer 3D printing – Open-source liquid cooled scalable printer design - ScienceDirect

Mosaic Palette Users, Create your own rainbow filament

E3D Titan Aero toolhead for Lulzbot TAZ

3D Printing Troubleshooting Guide