Prints stuck at layer 2 with Prusa Slicer

I'm having some issues with progress estimates and the displayed current layer does not go past 2. Prints fine. Running RepRapFirmware 3.1.1 but the issue was also present with 2.05 before upgrading Update: The total layer count on this specific print is

Stuck at preparing infill with only infill where needed enabled 1.41.2 · Issue #1696 · prusa3d/PrusaSlicer · GitHub

Insert pause or custom G-code at layer

V-Core 3.1 Commissioning Guide

The Ultimate Guide to 3D Printer Extruder - DYZE DESIGN

SOme parts of model disapear after slicing - UltiMaker Cura - UltiMaker Community of 3D Printing Experts

PrusaSlicer Coaster Set by Vector3dArt, Download free STL model

Prusa Slicer Bridging. How on earth should this work? Instead of bridging the entire top layer, it prints the posts & then tries to bridge (without having a place to attach the

Prusa FINALLY Added Arc Welding Support! PrusaSlicer 2.7

3D Printer Troubleshooting Guide

AnkerMake M5C 3D Printer, 500 mm/s High-Speed Printing, All-Metal Hotend, Supports 300℃ Printing, Control via Multi-Device, Intuitive, 7×7 Auto-Leveling, 220×220×250 mm Print Volume : Industrial & Scientific

Collapsing Master Sword with Replaceable Blade - 3D model by 3dprintingworld on Thangs

Weird tool path in print, possible to edit? – Hardware, firmware and software help – Prusa3D Forum

Prints stuck at layer 2 with Prusa Slicer

Why print small bits first - Prusa Slicer Question : r/prusa3d