Extra Retraction at Start - UltiMaker Cura - UltiMaker Community

Can someone explain why I am getting an extra retraction command right before my skirt starts? When I print, the filament doesn't print for sometime because of the extra retraction. I have tried it in both 3.4.1 and 3.5. Maybe I have a setting that is checked or set wrong. Below is my gcode from

ultimaker cura - Extruder doesn't retract on inner wall lines

First layers K8400 - Software (Repetier & Cura) - Whadda forum

slicing - Ultimaker Cura not always telling extruder to retract

Scalable extra prime - UltiMaker Cura - UltiMaker Community of 3D

Cura not retracting correctly - UltiMaker Cura - UltiMaker

4.7.0] Retraction Extra Prime Amount - Only on First Layer · Issue

Cura Settings Decoded – An Ultimaker Cura Tutorial

Retraction issue at layer change - UltiMaker Cura - UltiMaker

slicing - Ultimaker Cura not always telling extruder to retract