BUG] Additional retract when linear advance is on. · Issue #19982 · MarlinFirmware/Marlin · GitHub

i have problem on 0.2 mm nozzle and 0.1 mm layer height. Marlin.zip Marlin 2.0.7.1 And I tried to fix this problem, which worked properly by deleting the original retract, but then it crashed due to other retractions. the slicer is cura

BUG] Rapid changes of acceleration break linear advance when using

LINEAR ADVANCE 2.0 · Issue #10812 · MarlinFirmware/Marlin · GitHub

BUG] Bulge on linear advance speed change · Issue #16880

Bug in Linear Advance 1.5, causes extruder motor to stop for

32-bit] Extruder no longer steps when Linear Advance is enabled

BUG] Bulge on linear advance speed change · Issue #16880

Marlin 2.1.1 for G32 with Linear Advance without uart mod : r

Bug in Linear Advance 1.5, causes extruder motor to stop for

Bug in Linear Advance 1.5, causes extruder motor to stop for

Bug in Linear Advance 1.5, causes extruder motor to stop for