M600 refuses to work? Dual extruder issue - Snapmaker 2.0

So, I’m trying to pause my print to inlay a laser engraving. I can not for the life of me get M600 to work for some reason. I’m printing solely with Extruder 2(T1) and every which way I enter the M600 command, it just skips right past it. Not sure what I might be doing wrong. These are the methods I’ve tried; M600 T1; T1 M600; T1; M600; T0 M600;(interestingly, this switches to Extruder 1(T0) and then proceeds through the print as if M600 was not there at all. I believe I’ve also tried str

Snapmaker2-Controller/Marlin/Configuration.h at main · Snapmaker

Instructions, Embedding a mesh into 3D print

Dual Extruder simply does not work - Snapmaker 2.0 - Snapmaker

Linear Advance Factor

S8 Sunlu 3D printer

Dual extruder stops to extrude - Snapmaker 2.0 - Snapmaker: where

Dual Extruder simply does not work - Snapmaker 2.0 - Snapmaker

Creality CR-M4 - 3DJake Switzerland

Dual Extrusion Head: Heat creep discussion thread - Snapmaker 2.0

Instructions, Embedding a mesh into 3D print

Creality Ender 5 S1 Review - 3D Printer Testing and Settings

How To Succeed When 3D Printing With PVA Support Material

S8 Sunlu 3D printer

Dual Extruder Problems & Gripes Mega Thread - Snapmaker 2.0

Mintion, Beagle V2 Camera