Question about Cura gcode - Improve your 3D prints - UltiMaker Community of 3D Printing Experts

I have entered my own Start Gcode and End Gcode into the printer settings, see attached screenshots. However, as you can see, Cura also adds its own lines of Gcode that I don't need or want. Does anyone know where these lines come from, and how to prevent them happening?Thanks.

3D printing: What you need to know to get started, Articles

How to Use Cura Slicer with Klipper 3D Printer Firmware

Flow change not showing - UltiMaker Cura - UltiMaker Community of 3D Printing Experts

G-Code issue with Cura 4.13.1 - UltiMaker Cura - UltiMaker Community of 3D Printing Experts

Ultimaker Cura problems with build platform size and overhang support - 3D Printing Stack Exchange

Cura not allowing full print area to used - 3D Printing Stack Exchange

how to generate a g-code that use G2/G3 for circle - UltiMaker Cura - UltiMaker Community of 3D Printing Experts

Cura: All You Need to Know Before Getting Started - 3Dnatives

3D Printing Troubleshooting: All Problems & Solutions

MatterControl 2.0 with Cura 4.7.1 - UltiMaker Cura - UltiMaker Community of 3D Printing Experts

G-Code issue with Cura 4.13.1 - UltiMaker Cura - UltiMaker Community of 3D Printing Experts

Ultimaker Cura - An Overview for Makers - Tutorial Australia